SIG Sauer P320 Manual Safety Delete Kit, USED. (USES YOUR EXISTING MANUAL SAFETY TRIGGER BAR)
This kit (1 pin) is used to remove the manual safety from an existing P320 with factory manual safety. Includes a USED SIG P320 safety lever pin. Works with most upgraded P320s in 9mm, 40SW, 357SIG and 45ACP (for conversion or non-manual safety versions only). Keep your existing P320 manual safety trigger bar. Using the standard trigger bar is not recommended as the trigger bar will hang up in the manual safety pocket not allowing the trigger to reset.
CONDITION WILL VARY. ALL PINS CAME FROM FUNCTIONAL PISTOLS.
Removing the manual safety lever will leave the slot open in your existing grip. A standard grip without the manual safety notch is required. See grips HERE.
Includes: SIG Sauer P320 safety lever pin, USED. (SIG #1300674-R, Loose, bulk packaging). Grease, wear, etc. may be present. No Slide, trigger bar, chamber flag, grip, etc. included
Installation is available for an additional charge.
Complete lower parts kit can be purchased HERE
Grip modules can be found HERE
5 Reviews Hide Reviews Show Reviews
Works as advertised. Barely any sign of use on it and quick installation. Would highly recommend
I can't even tell that the product is used
Didn’t even looked used popped her right in and using my stippled xcarry frame
I love it! Works just as described. No issues after installation. I just watched a few YouTube videos to see the process and it was easy to do! I also was really surprised being used because it looks brand new like it was never used. Definitely recommend!
Hardly a mark on it. Functioned just fine.